• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Planning an adhesive-free grip zone

A dry grip zone gives the user somewhere to hold a cosmetic patch while opening the pack. Its location affects the usable adhesive area and the size of the carrier underneath.

Show the grip on a layered drawing

Mark the outline of the finished piece and shade the area that should remain free of exposed adhesive. Indicate whether the dry zone is part of the patch, an extended liner or a removable tab. These three constructions can look similar in a front-facing photograph.

Try the smallest intended format

Open examples from the intended tray or sachet using the proposed grip. Check whether fingers can reach the dry area without pinching the adjacent coated edge. Record where the patch bends when lifted, particularly on small dots or the narrow end of an under-eye crescent.

Include the grip in the purchase sample

Agree how much area can be occupied by this feature and where alignment is checked on the assembled item. If more room is needed, compare moving the tab with enlarging the entire part. Set aside a labelled example showing both the intact grip and the peeled condition.

Frequently asked questions

Does a dry edge mean adhesive coverage is reduced everywhere?

The design can restrict the uncoated region to a specific grip area. Request a marked adhesive-coverage map and an actual sample to confirm its location on the part.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.