Keep unlike peel measurements separate
Separating a release liner from an adhesive is different from peeling the adhesive from a test surface. Include the peel angle, rate, width and conditions when comparing data.
Supplier technical sheets may report both figures on the same page. Match each test to the correct interface before drawing a conclusion about handling.
Observe real opening problems
A liner that releases unevenly can bend a thin patch or cause the wrong corner to lift. Collect a short video or sequence of photographs showing where the peel begins and how it travels.
Check whether the proposed tab helps start the motion and whether the shape remains supported after separation. Include the whole packed prototype to reveal access issues.
Agree how the team will judge incoming packs
Decide which test information will be recorded and which qualitative observations trigger a review. A stated acceptance criterion is more useful than relying on words like easy peel.
Link the opening reference to a lot, liner and adhesive revision. Recheck it when any supplier proposes changing the liner coating or patch outline.
- Named test and sample conditions
- Opening observation in the final pack
- Approved reference with lot identity
Frequently asked questions
Should the release force be as low as possible?
Set a window suited to stable storage and smooth handling. Review how the pack opens and whether neighboring patches stay anchored.