• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Reading peel, tack and shear data for cosmetic patch backing

Peel, tack and shear address different parts of adhesive behavior. Know which question each measure can answer before sorting tape options by one number.

Separate the terms

Tack describes initial attachment under specified contact conditions. Peel describes the force involved in progressive separation at a stated angle and speed. Shear assesses movement or holding under a load along the interface.

Each result depends on how it was obtained. A technical sheet describing stainless steel or another defined surface helps compare material tests in that setup.

Choose what to observe on supplied patches

For initial attachment, check positioning and the ease of laying down the expected outline. For later attachment, review edges and any movement over the intended time period.

For removal, look at the backing and the placement area after peeling. Record the direction and any folding so the next tester can reproduce the handling.

Use values as evidence with a named context

Ask for the test surface, conditioning and units before setting a target. Where the underlying method differs between suppliers, repeat a matched comparison on samples.

The project owner should keep numerical data, material lists and visible handling observations together. This reduces pressure to substitute one headline number for a complete selection.

  • Test surface, direction and dwell
  • Matched finished-patch sample
  • Separate attachment and removal notes

Frequently asked questions

Can a peel-to-steel value predict skin wear by itself?

Use it as a controlled material result. Finished fit, adhesive geometry and handling need separate review.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.