• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Ordering patch backing tape in rolls

Roll width alone leaves important purchasing questions open. A material that fits the finished patch may still arrive on a core or in an unwind direction that the converter cannot use.

Specify the machine-facing details

Ask the receiving converter for its acceptable core inside diameter, maximum roll diameter and winding orientation. Supply a sketch showing which face is exposed as the roll unwinds. Indicate the required web width and whether the edges are trimmed before entering the next operation.

Define usable material

State whether the purchase unit is linear length, roll count or an agreed number of usable parts. Ask how splices are identified and whether the converter can run through them. A nominal roll length alone does not explain what the packing team should do with a marked splice.

Agree identification on delivery

Request outer labels showing the grade, lot, width and winding reference for each roll. Make sure the first trial uses the same orientation as the purchase specification. Keep a photograph of the label and an arrow showing the unwind direction in the converter's receiving instructions.

Frequently asked questions

What if the converter needs several narrow widths?

Send the list of required widths, quantities and compatible core dimensions together. The supplier can then propose a slitting arrangement and identify any constraints specific to the feed equipment.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.