• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Tracing delamination in a cosmetic patch sample

When a patch separates into layers, retain both halves before anyone tries to stick them together. Where the material remains after separation helps identify the specific joint to investigate.

Photograph the two faces together

Position both halves beside the original sample identifier. Keep the orientation visible and include an intact example from the same delivery. Identify whether the separation happened during opening, while attaching a component or after a review on a model. These events expose different interfaces in the assembly.

Map the visible separation

Use the layer drawing to mark which carrier, coating or component is still visible on each side. Record uncertain areas as observations. A glossy surface can resemble exposed adhesive in a photograph, so request confirmation from the converter before assigning a cause or changing the adhesive grade.

Propose a targeted repeat

Set aside unopened pieces from the same lot and compare them with the retained reference under the same opening conditions. If only one region separates, mark its position against the cut outline. Ask whether a change in assembly, liner or packed orientation also occurred between the two samples.

Frequently asked questions

What should I send with a delamination inquiry?

Include photographs of both separated surfaces, an intact sample, the layer order and the event that preceded separation. Identify any recent material or drawing changes with dates.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.