• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Specifying patch thickness with and without the liner

Two quotes can give different thicknesses for the same tape when one includes the liner and the other describes the working laminate. Start by deciding which measurement matters to the tray, the converter and the finished patch.

Separate the three dimensions

List the carrier thickness, the coated laminate thickness and the packed assembly thickness in separate rows. Label units on every row. For a shaped patch with a raised centre, mark where each thickness applies. A measurement from the border cannot describe how much clearance the centre needs.

Ask how the value was obtained

Read the supplier's technical sheet for the named grade and check whether the value is typical, nominal or an agreed acceptance range. Ask which layers were present during measurement and whether a soft or compressible layer could change the reading under pressure. Keep the method with the number.

Check the downstream fit

Place the approved patch on its specified liner in the proposed tray. Inspect whether the protective cover clears the part and whether stacked trays sit properly. Record the tray version when signing off pack clearance so a later buyer can trace the original thickness assumption.

Frequently asked questions

What should purchasing put on the order?

Reference the approved material code, drawing revision and agreed thickness definition. Include the applicable measurement location and unit when the order calls out a dimension separately.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.