• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

Polyethylene film backing for a cosmetic patch

If the sample drawing says PE tape, ask which polyethylene film and adhesive the supplier used. A transparent patch photograph gives no reliable way to distinguish PE from another clear film.

English diagram of the small eye patch back view with width and height annotations
Small eye patch drawing, 54.07 × 23.77 mm. The back view identifies the liner and tear line.

Identify the exact construction

Find the material identifier on the roll label or the supplier's sheet. Identify the carrier, coated face and removable liner, along with the unit used for each thickness. A quote for film alone can omit the adhesive and liner that give the finished piece its handling characteristics.

Review what the wearer handles

Request an unprinted outline and an assembled patch in the proposed PE construction. Hold each by the intended tab, remove the liner and look for folding at narrow tips. Note whether the operator touched the contact area to flatten a corner. Take a photograph immediately after lifting the patch from its tray.

Compare two examples fairly

When a second carrier is proposed, repeat the opening review using the same outline, inner pack and product version. Ask which differences come from film choice and which from an altered adhesive or thickness. Put each material code next to its photograph so a buyer can select the same construction again.

Frequently asked questions

Does PE on the drawing identify the adhesive?

PE identifies the polymer used in the named layer. Ask the supplier to identify the coating separately and state which face of the assembly will contact skin.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.