• Private-label cosmetic microneedle eye patches
  • Liner and perimeter review
  • Matched prototype comparison

How to specify roll splices in patch backing

A backing roll can have the right width and adhesive yet stop the converting line at the first splice. Agree how the operator will find the joint and which patches to segregate before placing a repeat order.

Draw the joint as the operator will see it

Show the unwind direction and identify the adhesive face and release liner. In a butt splice the web ends meet edge to edge and tape bridges them. A lap splice overlaps the two ends. Ask the converter to check the resulting step against the guides and die clearance.

Make the splice detectable

Ask for a marked sample from a short roll. Specify which edge carries the flag, whether a sensor or operator reads it, and how each splice is recorded on the roll label. Agree a maximum number per roll with the supplier.

Define the material to set aside

Run the sample through the intended line. Record the last acceptable patch before the joint and the first acceptable one after it. Add the resulting rejection rule and a photograph of the approved joint to the purchase specification.

References

Share this requirement with our team

Share the intended patch size, backing preference, pack format, target market and branding requirements.